Phone: (+65) 6562 8716 | Email: singapore@turckbanner.com

Liquid Level Monitoring In A Large Tank

In liquid level monitoring applications a long range sensor is needed to ensure it can reach and sense the full depth of the tank for accurate monitoring.

By sending a continuous signal that represents the current depth, the tank levels can be controlled with a pump in-pump out logic.

Banner Engineering’s U-GAGE QT50U ultrasonic analog long distance sensor has a narrow sensing beam that works in restrained areas, such as the tank, without interference from the tank walls and senses with an extended range up to 8 m. The ultrasonic sensor can be mounted to the center so that the beam spreads over the tank to detect the fluid level without interference while signaling when to pump out excess liquid and pump in additional liquid.

Your Benefits

  • Built in, pump in-pump out logic can control the tank level without the cost of external controls.
  • Long 8m Range to reach the bottom of the tank.
  • Analogue and Digital outputs for measurement and warning levels.

  • Banner's QT50U Ultrasonic Sensor Has an Extended Range up to 8m That Reaches the Full Depth of a Tank  

The QT50U ultrasonic sensor is extremely powerful and has the most extended range to work well in applications and features an ultrasonic dead-zone of only 2.5% of the entire range, which is 75% less than comparable products. The QT50U is available with AC voltage and has analog capability with low level and high-level outputs and push-button capability.

The setup with the QT50U ultrasonic sensor is simple with the push-button and remote TEACH-mode programming and showing highly visible LED indicators for status during installation.