Phone: (+65) 6562 8716 | Email: singapore@turckbanner.com

Detection of Valve Position

When a sensor with terminal chamber is replaced, the single strands have to be disconnected and reconnected to the new sensor. This should only be performed by specially trained personnel like electricians. This is especially important if the sensor fails during the night shift when the special personnel are not available. Once the wires have been connected to the terminal of uprox+ WD then the whole terminal can be unplugged and plugged again like a coded connector. This may also be done by workers without this special training.

Your Benefits

  • Inductive uprox+ WD sensors with terminal chamber and removable clamps are easily installed and removed again
  • High tightness and resistance to chemicals
  • Increased switching distance on all metals 

  • Valves in a beverage plant

  • Turck's uprox+ EM18-WDTC

Select Country

Turck worldwide